Table of Contents
Advertisement
Assembly
Install Handles
1. Mount handle to outside of mower housing, using
bottom hole, with (2) 5/16–18 x 1–1/4" lg. capscrews,
washers, and thin nylon insert locknuts.
Figure 2
1. Handle
2. Handle latch
3. Bag support rod
2. Secure handle latches to handle with (2) 5/16–18 x
1–1/2" lg. capscrews, washers and nylon insert
locknuts. Position locknuts and washers on inside of
handle.
Note: Handle height is adjustable for operator comfort.
Stand behind mower handle to gauge height. To adjust
handle height, reposition capscrews and locknuts securing
handle latches to handle into other mounting holes in
latches.
3. Slide bag support rod thru top mounting holes in
handle and secure each end with a cap locknut (Fig. 2).
4. Secure control cables in position with cable ties.
Install Gas Tank and Fuel Line
1. Start self–tapping screws into bottom of gas tank and
then remove screws.
2. Hook the plastic clips on the rear of the gas tank onto
gas tank bracket (Fig. 3).
534
4. Cap locknut
5. Cable tie
Figure 3
1. Self-tapping screws
2. Gas tank
3. Plastic clips
4. Gas tank retainer
3. Secure gas tank to tank base with the (2) self–tapping
screws (Fig. 3). Do not overtighten screws.
4. Hook gas tank retainer onto gas tank and slide end of
retainer into hole in tank bracket. Secure retainer to
tank bracket with locknut (Fig 3). Do not overtighten.
5. Slide end of fuel line onto elbow fitting. Secure in
place with fuel line clamp (Fig. 4).
Figure 4
1. Fuel line
2. Elbow fitting
8
m-2942
5. Gas tank bracket
6. Locknut
7. Tank base
3. Fuel line clamp
Advertisement
Table of Contents
