Table of Contents
Advertisement
1. If necessary, remove grass bag.
2. ADJUSTMENT (Fig. 24)—Rotate control knob
clockwise 1/2 turn if mower does not self–propel. If
mower creeps forward, rotate knob 1/2 turn
counterclockwise to loosen belt.
1
Figure 24
1. Control knob
3. CHECK ADJUSTMENT—Slowly pull mower
backward while self-propel control bar is gradually
moved toward handle. Adjustment is correct when rear
wheels stop turning and self-propel control bar is about
25 m (1 inch) from handle (Fig. 25).
4. Repeat steps 2 and 3 until properly adjusted.
2,5 CM
(1 INCH)
Figure 25
Adjusting Ground Speed
Control Cable
1. Move the ground speed control (Fig. 13) to N
(neutral). Make sure the control is all the way back in
the N slot.
2. Loosen the clamp screw (Fig. 26).
2
m-4315
1
4
1. Clamp screw
2. Shift lever
3. Push the shift lever until it is tight against the stop
(Fig. 26).
4. Pull all slack out of the ground speed cable and tighten
the clamp screw.
If the mower does not drive when the ground speed
m-4323
control is in one of the three speed slots, make sure the
ground speed control is positioned fully forward in the
desired speed slot.
Inspecting/Removing/
Sharpening Blade
1. Stop engine and pull wire off spark plug.
18
3
Figure 26
3. Stop
4. Ground speed cable
m–4326
Advertisement
Table of Contents
