Safety And Instruction Decals; Assembly; Install Wheels - Toro 38409 Operator's Manual

29. To ensure best performance and safety, purchase
genuine TORO replacement parts and
accessories to keep your TORO all TORO.
NEVER USE "WILL FIT" REPLACEMENT
PARTS AND ACCESSORIES.

Safety and Instruction Decals

Safety decals and instructions are easily visible to the operator and are located near
any area of potential danger. Replace any decal that is damaged or lost.
ON INSIDE OF BELT COVER

Assembly

Note: Determine left and right sides of the
snowthrower by standing in the normal
operator's position behind the handles.
Install Wheels (Fig. 2)
1. Carefully turn machine onto its left side. Place a
wood block under the left axle end.
2. Slide the short spacer and a wheel onto the right
axle end. The side of the wheel with six spokes
must face the center of the machine.
(Part No. 60–9480)
ON HANDLE
(Part No. 66–6870)
3. Slide a pushnut onto the end of the axle.
4. Using a hammer, strike the pushnut to seat the
nut FIRMLY in place.
5. Turn the machine over on its right side so that
the left axle end is pointing up.
6. For the left side, slide the long spacer and a
wheel onto the left axle end. The side of the
wheel with six spokes must face the center of the
axle.
7. Place a wood block under the right axle end.
Repeat steps 3 and 4.
ON CHUTE
(Part No. 94–2900)
4