Table of Contents
Advertisement
1. Height-of-cut lever
2. Height-of-cut positions
1. Pull up and inward on the lever to move it to the
desired cutting position.
2. Once at the desired cutting position, slowly lower the
lever until it engages the position.
The transport position is the highest height-of-cut position or
cutting height 4.5 inch [115 mm] (Figure 20).
Positioning the Seat
1. Raise the seat and loosen the adjustment bolts just
enough that seat can move (Figure 21).
1
1. Adjustment bolt
2. Move the seat to the desired position and tighten the
bolts.
Figure 20
3. 4.5 inch (115 mm),
Transport position
G014477
Figure 21
Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or lower for
maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 22).
2. Move the control lever to the next set of holes. Secure
the lever with the 2 bolts (Figure 22).
G014970
1. Control arm shaft
2. Control lever
3. Repeat the adjustment for the opposite control lever.
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever fore or aft (Figure 22). Tighten both bolts to
secure the control in the new position.
3. Repeat the adjustment for the opposite control lever.
Pushing the Machine by Hand
Important: Always push the machine by hand. Never
tow the machine because damage may occur.
This machine has an electric brake mechanism and to push
the machine the ignition key needs to be in the Run position.
The battery needs to be charged and functioning for the
electric brake to be disengage.
To Push the Machine
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to park
position, stop the engine, and wait for all moving parts
to stop before leaving the operating position.
18
2
1
3
4
Figure 22
3. Slotted, upper hole
4. Bolt
Advertisement
Table of Contents
