Listening To The Radio - Onkyo TX-L5 Instruction Manual

Listening to the Radio

There are two ways to select radio stations:
• Manual tuning
• Presetting radio stations then selecting the preset
channels
Tuning Manually
1
Turn INPUT dial to select the band
INPUT (FM or AM).
e.g. When FM is selected.
2
Turn VOLUME dial to adjust the
VOLUME
volume.
3
Press and hold TUNING/PRESET
™/£ for about 1.5 seconds.
TUNING/PRESET
Appears when a broadcast is received.
When the band is FM
Auto tuning starts. The frequency changes in
50 kHz steps.
When a broadcast is received, scanning stops
and the frequency flashes in the display.
When the band is AM
The frequency changes as follows:
– (USA and Canadian models)
In 10 kHz steps
– (Other models)
In 9 kHz steps
When you release the button, the frequency
stops changing and flashes in the display.
Note
If you press and hold TUNING/PRESET ™/£
short time, the AV receiver enters the selecting
preset stations mode. Refer to "Selecting
Preset Stations" on page 24.
STANDBY / ON
ON
DVD / C D VIDEO 1 VIDEO 2 H D MD / TAPE
FM AM
STANDBY
PHONES
POWER SURROUND STEREO
ON OFF
The corresponding indicator
is lit while the input source
is FM or AM.
4
While the frequency is flashing (for
about 3 seconds), press TUNING/
TUNING/PRESET
PRESET ™/£ to change the
frequency.
• The frequency changes each time you
press TUNING/PRESET ™/£.
• You can change the frequency as long
as the frequency in the display is
flashing. Each press of either button
causes the frequency to flash for about
3 seconds.
I Tuning in a weak frequency (only for FM
stations)
When you tune in a stereo FM station, the FM STEREO
indicator lights up if the signal is sufficiently strong.
If the signal is weak, you may not be able to tune to the
station. In this case, press FM MODE. The FM MUTE
indicator goes off.
Then select the station to which you want to listen.
(At this time, the station will be in mono and interstation noise
will be heard.)
FM MODE
I Receiving RDS (European models only)
When an Radio Data System (RDS) station broadcasting
Program Service Name (PS) information is received, the RDS
indicator lights up and the name of the station is displayed.
• RDS reception is only available on the European models,
and only in areas where RDS broadcasts are available.
FM MODE INPUT dial
VOLUME
INPUT
ACOUSTIC
SUBWOOFER MODE MEMORY FM MODE TUNING/PRESET CONTROL
TX-L
AV RECEIVER
TUNING/PRESET ™/£
VOLUME
dial
5
RDS
23