Basic Operations; Selecting The Language Used For The Onscreen Setup Menus; Playing The Connected Component; Displaying Source Information - Onkyo HT-R980 Instruction Manual

Basic Operations

The on-screen menus appear only on a TV that is con-
nected to the HDMI OUT. If your TV is connected to
the MONITOR OUT V or the COMPONENT VIDEO
OUT, use the AV receiver's display when changing
settings.
This manual describes the procedure using the
remote controller unless otherwise specified.
Selecting the Language Used for the
Onscreen Setup Menus
You can determine the language used for the onscreen
setup menus. See "Language" in the "OSD Setup"
48).
(➔

Playing the Connected Component

■
Operating on the AV receiver
1
Use the input selector buttons to select the input
source.
2
Start playback on the source component.
See also:
• "Controlling Other Components"
• "Controlling iPod" (➔
• "Listening to the Radio"
3
To adjust the volume, use the MASTER VOLUME
control.
4
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes"
• "Audyssey" (➔ 43)
■
Operating with the remote controller
1
Press RECEIVER followed by INPUT SELEC-
TOR.
2
Start playback on the source component.
See also:
• "Controlling Other Components"
• "Controlling iPod" (➔
• "Listening to the Radio"
3
To adjust the volume, use VOL q/w.
4
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes"
43)
• "Audyssey" (➔
60)
(➔
56)
26)
(➔
30)
(➔
(➔ 60)
56)
26)
(➔
(➔ 30)

Displaying Source Information

You can display various information about the current
input source as follows. (Components connected to the
UNIVERSAL PORT jack are excluded.)
Press RECEIVER followed by DISPLAY repeat-
edly to cycle through the available information.
Tip
• Alternatively, you can use the AV receiver's DISPLAY.
The following information can typically be displayed.
Input source &
*1
volume
Signal format *2
or sampling
frequency
Input & output
resolution
Input source &
listening mode *3
*1
When AM or FM radio is used, the band, preset number, and
frequency are displayed.
*2 If the input signal is analog, no format information is dis-
played. If the input signal is PCM, the sampling frequency is
displayed. If the input signal is digital but not PCM, the signal
format is displayed.
Information is displayed for about three seconds, then the pre-
viously displayed information reappears.
*3 The input source is displayed with the default name even
when you have entered a custom name in "Name Edit"
(➔ 45).

Setting the Display Brightness

You can adjust the brightness of the AV receiver's display.
Press RECEIVER followed by DIMMER repeat-
edly to select: dim, dimmer, or normal brightness.
Tip
• Alternatively, you can use the AV receiver's DIMMER (North
American models).
En
21