Checking the Engine Oil
Level
1. Remove the dipstick, wipe it clean, and fully
install the dipstick.
m-7317
Adjusting the Cutting Height
Adjust the cutting height
as desired. Set all four
wheels to the same
height.
Adjusting the Handle Height
Squeeze the bottom of
the handle halves
together (as shown) and
change the handle holes
in which the pins (A) are
mounted, as follows:
Raise the handle
•
using hole (B).
Lower the handle
•
using hole (C).
m-7310
m-7317
C
B
A
3352-580
6
2. Remove the dipstick and check the oil level. If the
oil level is below the Add mark on the dipstick,
slowly pour oil into the oil fill tube to raise the oil level
to the Full mark on the dipstick. Do not overfill.
(Max. fill: 20 oz., type: SAE 30 detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or
higher.)
3. Install the dipstick.
1-1/4,
m-5629
m-5614
2-3/4,
3-1/2,
2,
4-1/4,
2-3/8,
3-1/8,
1-5/8,
3-7/8,
FRONT
m-5605a
m-5612a