Maintenance; Recommended Maintenance Schedule(S); Preparing For Maintenance - Toro Recycler 20999 Operator's Manual

– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your machine.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full swath
with each pass.
– Set the cutting height on the front wheels 1 notch
lower than the rear wheels. For example, set the front
wheels at 51 mm (2 in) and the rear wheels at 64 mm
(2-1/2 in).

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
Before each use or daily
Every 25 hours
Every 50 hours
Yearly
Yearly or before storage
Important: Refer to your Engine Operator's Manual for additional maintenance procedures.

Preparing for Maintenance

1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the spark-plug wire from the spark plug
(Figure 35) before performing any maintenance
procedure.
Figure 35
3. After performing the maintenance procedure(s),
connect the spark-plug wire to the spark plug.
Maintenance Procedure
• Change the engine oil.
• Check the engine oil level.
• Ensure that the engine stops within 3 seconds after releasing the blade-control bar.
• Clean the underside of the machine housing.
• Replace the air filter yearly; replace it more frequently in dusty operating conditions.
• Change the engine oil; change it more frequently in dusty operating conditions.
• Lubricate the wheel gears.
• Lubricate the upper handle.
• Change the engine oil; change it more frequently in dusty operating conditions.
• Replace the blade.
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn shows
through the cut leaf cover. You may need to make more
than a single pass over the leaves.
•
If there are more than 13 cm (5 in) of leaves on the lawn,
set the front cutting height 1 or 2 notches higher than
the rear cutting height.
•
Slow down your mowing speed if the machine does not
cut the leaves finely enough.
Important: Before tipping the machine to change
the oil or replace the blade, allow the fuel tank to
run dry through normal usage. If you must tip
the machine prior to running out of fuel, use a
hand fuel pump to remove the fuel. Always tip the
machine onto its side with the dipstick down.
WARNING
Tipping the machine may cause the fuel to
leak. Gasoline is flammable, explosive and
can cause personal injury.
Run the engine dry or remove the gasoline
with a hand pump; never siphon.
14