Bleeding The Hydraulic System - Toro 74266CP Operator's Manual

1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
Important: Do not substitute automotive oil
filter or severe hydraulic system damage may
result.
3. Place drain pan under filter, remove the old filter
and wipe the filter adapter gasket surface clean
(Figure 80).
1. Hydraulic filter
4. Remove the righthand hydraulic line that comes into
the adapter (Figure 81).
5. Allow the oil to drain out of the system into the
drain pan.
6. Install the righthand hydraulic line to the adapter
(Figure 81).
1. Righthand hydraulic line
2. Hydraulic filter
7. Apply a thin coat to the rubber gasket on the
replacement filter (Figure 82).
8. Install the replacement hydraulic filter onto the filter
adapter. Do not tighten.
Figure 80
Figure 81
3. Hydraulic tank
9. Fill the hydraulic tank with hydraulic fluid until the
fluid overflows the filter and then turn the oil filter
clockwise until the rubber gasket contacts the filter
adapter, then tighten the filter an additional 1/2 turn
(Figure 82).
10. Clean up any spilled fluid.
11. Add fluid to the cold level of the baffle in the
hydraulic tank.
12. Start the engine and let it run for about two minutes
to purge air from the system. Stop the engine and
check for leaks. If one or both wheels will not drive,
refer to Bleeding Hydraulic System.
13. Recheck the fluid level while the fluid is warm. The
fluid should be between cold and hot.
14. If required, add fluid to the hydraulic tank. Do not
overfill.
1. Hydraulic filter
2. Gasket

Bleeding the Hydraulic System

The traction system is self bleeding, however, it may be
necessary to bleed the system if fluid is changed or after
work is performed on the system.
1. Raise rear of the machine so wheels are off the
ground and support with jack stands.
2. Start the engine and run at low idle speed. Engage
the lever and traction on one side and spin the wheel
by hand.
3. When the wheel begins to spin on its own, keep it
engaged until wheel drives smoothly. (minimum
2 minutes)
4. Check hydraulic fluid level and add as required to
maintain proper level.
5. Repeat this procedure on the opposite wheel.
55
Figure 82
3. Adapter