Preparing The Remote Controller - Onkyo FR-N3X Instruction Manual

Preparing the remote controller

N
Inserting the batteries
1
2
3
Notes
• Do not mix new batteries with old batteries or different
kinds of batteries.
• To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long period of time.
• Remove dead batteries immediately to avoid damage
from corrosion. If the remote controller does not operate
smoothly, replace both batteries at the same time.
• The life of the batteries supplied is about six months but
will vary depending on usage.
Detach the battery
cover.
Insert the two R6
(size AA) batter-
ies.
Be sure to match the
+ and – ends of the
batteries with the dia-
gram inside the bat-
tery compartment.
Attach the battery
cover.
N
Using the remote controller
Point the remote controller toward the remote control
sensor.
Remote control
sensor
Notes
• Place the unit away from strong light such as direct sun-
light or inverted fluorescent light, which can prevent
proper operation of the remote controller.
• Using another remote controller of the same type in the
same room or using the unit near equipment that uses
infrared rays may cause operational interference.
• Do not put any object, such as a book, on the remote
controller. The buttons of the remote controller may acci-
dentally be pressed and drain the batteries.
• Make sure the audio rack doors do not have colored
glass. Placing the unit behind such doors may prevent
proper remote controller operation.
• If there is an obstacle between the remote controller and
the remote control sensor, the remote controller will not
operate.
13