Inspect The Fuel Filter - Toro 04380 Operator's Manual

Exxon
Kendall
Phillips
Shell
Union Oil
Note: The fluids within this group are interchangeable.
Group 2 Hydraulic Fluid (Recommended for ambient
temperatures consistently below 70° F)
ISO type 46/68 anti-wear hydraulic fluid
Mobil
Shell
Amoco
Arco
Boron
BP Oil
Castrol
Chevron
Citgo
Conoco
Exxon
Gulf
Pennzoil
Phillips
Standard
Texaco
Union
Note: The fluids within this group are interchangeable.
IMPORTANT: Two groups of hydraulic fluid are
specified to allow optimal operation of the machine in
a wide range of temperatures. The group 1 fluids are
multi-viscosity fluids, which allow operation at lower
temperatures without the increased viscosity
associated with straight viscosity fluids.
Using the Mobil 424 type fluids in the higher ambient
temperatures may result in decreased efficiency in some
of the hydraulic components compared with using the
Mobil DTE 26 type fluids.
The Mobil DTE 26 type fluids are straight viscosity
fluids which remain slightly more viscous at higher
temperatures than the multi-viscosity fluids.
Using the Mobil DTE 26 type fluids in the lower
ambient temperatures may result in harder starting,
increased engine laboring while cold, sluggish or non-
operating valve spools while cold and increase filter back
Torque fluid
Hyken 052
HG fluid
Donax TD
Hydraulic/Tractor fluid
DTE 26 or DTE 16
Tellus 68
Rykon Oil 68
Duro AW S-315
Industron 53
Energol HLP68
Hyspin AWS68
Chevron EP68
Citgo A/W68
Super Hydraulic Oil 31
Nuto H68
68AW
IAW Hyd Oil 68
Magnus A 315
Industron 53
Rando HD68
Unax AW 315
pressure.
It is recommended that you select the set of conditions
(either ambient temperatures above 70° F, or below 100°
F), and use that type of fluid throughout the year, instead
of changing fluid types several times during the year.
Group 3 Hydraulic Fluid (Biodegradable):
ISO type 32/46 anti-wear hydraulic fluid
Mobil
Note: This biodegradable hydraulic fluid is not
compatible with the fluids in group 1 or 2. Using this
hydraulic fluid may require an oil cooler kit (Model No.
04499) to be installed.
Note: When changing from one type of hydraulic fluid to
another, be certain to remove all the old fluid from the
system because some brands are not completely
compatible with other brands of hydraulic fluid.
Note: A red dye additive for the hydraulic system fluid is
available in19.8 ml bottles. One bottle is sufficient
for 22 L of hydraulic fluid. Order Part No. 44-
2500 from your Authorized Toro Distributor.
1. Position the machine on a level surface. Make sure
the machine has cooled down so fluid is cold.
2. Remove the cap from reservoir and check the level
of fluid. The fluid should be up to bottom of screen
in the filler neck.
1. Hydraulic reservoir cap
2. Screen
3. If the fluid level is low, slowly fill reservoir with
Before Operating
EAL 224 H
Figure 6
13