Controls - Toro 04380 Operator's Manual

Controls

Traction Pedal (Fig. 7)—The traction pedal has three
functions: 1) to make the machine move forward, 2) to
move it backward and 3) to stop the machine. Depress
the top of the pedal to move forward and the bottom of
the pedal to move backward or to assist in stopping
when moving forward. Also, allow the pedal to move to
the neutral position to stop the machine. Do not rest
your heel of foot on reverse, when operating forward
(Fig. 8).
1. Traction pedal
2. Brake pedal
3. Parking brake latch
2
1. Forward
2. Reverse
Brake Pedal (Fig. 7)—The brake pedal actuates an
automotive drum-type mechanical brake located at each
traction wheel.
Parking Brake Button (Fig. 7)—Depressing the brake
pedal to actuate the brake assembly, then depressing the
small button indicated will keep the brakes actuated for
parking. Disengage the parking brake by depressing the
brake pedal. Form the habit of locking the parking brake
before you leave the machine.
Choke Control (Fig. 9)—When starting a cold engine,
Figure 7
1
Figure 8
move the choke control forward. After the engine starts,
regualte the chokd to keep the engine running smoothly.
As soon as possible, move the choke rearward..
Functional Control Lever (Fig. 9)—Provides two (2)
traction selections, plus a "NEUTRAL" position. It is
permissible to shift from mow to transport or from
transport to mow (not to neutral) while the Greensmaster
3200 is in motion. No damage will result.
1. Rear Position—Neutral and backlapping.
2. Middle Position—Used for mowing operation.
3. Front Position—Used for transport operation.
1. Choke control
2. Functional control lever
3. Hour meter
4. Ignition switch
5. Steering arm locking lever
6. Water temperature light
7. Engine oil pressure light
8. Battery warning light
9. Two-speed engine switcht
10. Raise/Lower/Mow control
11. High temperature override button
Hour Meter (Fig. 9)—Indicates the total hours of
machine operation. The hour meter starts to function
whenever the key switch is turned to "ON".
Ignition Switch (Fig. 9)—Insert the key into the switch,
turn it clockwise as far as possible to the "START"
position to start the engine. Release the key as soon as
the engine starts; the key will move to the "ON"
position. Turn the key counter-clockwise to "OFF"
position to stop the engine.
Steering Arm Locking Lever (Fig. 9)—Rotate the lever
rearward to loosen adjustment, raise or lower the
steering arm for operator comfort, then, rotate the lever
Figure 9
15