Toro 74942TE Operator's Manual page 58

g024245
Figure 85
1. 76 mm (3 inches) at A is
correct
2. 8.3 cm (3-1/4 inches) at B
is correct
9. Fine-tune the adjustment nut on the front deck-lift
assembly by turning it (see
Note: To increase the height, turn the adjustment
nut clockwise; to decrease the height, turn the nut
counterclockwise.
Note: If the front deck links do not have enough
adjustment to achieve accurate cut height, you can
utilize the single-point adjustment to gain more
adjustment.
1
4
3. Measure here from the
blade tip to hard surface.
4. Measure at A and B on
both sides.
Figure 86).
2
1
2
3
1. Adjustment nut
2. Jam nut
10. To adjust the single-point system, loosen the 2 bolts at
the bottom of the height-of-cut plate
Note: To increase the height, turn the adjustment
nut clockwise; to decrease the height, turn the nut
counterclockwise
Note: Loosen or tighten the single-point adjustment
bolt enough to move the height-of-cut plate mounting
bolts at least 1/3 the length of the available travel in
their slots. This gains some up and down adjustment
on each of the 4 deck links.
1. Bolts at the bottom of the height-of-cut plate
58
4 3
Figure 86
3. Rear deck adjustment
4. Front deck adjustment
(Figure
(Figure 88).
Figure 87
2 1
g024669
87).