Product Overview; Controls - Toro 30032 Operator's Manual

Product Overview

1. Side discharge chute
2. Engine
3. Gas tank

4. Controls

Controls
Become familiar with all the controls (Figure 4) before
you start the engine and operate the machine.
1. Ignition switch
2. Left motion control lever
3. Throttle control
4. Hour meter
5. Fuel tank
Figure 3
5. Parking brake
6. Mower deck
7. Front caster wheel
Figure 4
6. Choke
7. Neutral lock position for
right motion control lever
8. Right motion control lever
9. blade control switch (PTO)
10. Operator manual tube
Throttle Control
The throttle control has two positions: Fast and Slow.
Choke
Use the choke to start a cold engine.
Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage
the electric clutch to drive the mower blades with the
right side motion control lever in the center, un-locked
position. Pull the switch up to engage the blades and
release. To disengage the blades, push the blade control
switch (PTO) down or move or release the right side
motion control lever into the neutral lock position.
Ignition Switch
This switch is used to start the mower engine and has
three positions: Start, Run and Off.
Motion Control Levers
The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system to engage and disengage the mower blades and
to determine neutral position.
Fuel Shut-off Valve
Close the fuel shut-off valve (under the fuel tank ) when
transporting or storing the mower.
Hour Meter
Shows the total hours the machine has been operated.
This operates only when the mower blades are operating.
The hour meter will flash 3 hours before and after a
service interval. The service intervals are set for the
first 8 hours, every 100 hours there after, and every 400
hours.
Note: Make sure maintenance is done at all
recommended intervals shown in the Recommended
Maintenance Schedule.
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
11