Correcting The Mower Quality Of Cut; Frame Set Up - Toro 30032 Operator's Manual

Figure 54
1. Blade
Installing the Blades
Important: The sail part of the blade must be
pointing upward, toward the inside of the mower to
ensure proper cutting (Figure 52).
1. Install the blade, stiffener, curved washer, and blade
bolt to the spindle (Figure 52).
2. Torque the blade bolt to 85-110 ft-lb (115-140 N-m).
Correcting the Mower Quality
of Cut
If one deck blade cuts lower than the other, correct as
follows.
Note: Tire air pressure is critical in these procedures.
Make sure all tires have correct pressure.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position. Disconnect the spark plug wire(s) from
the spark plug(s).
3. Adjust the tire pressure in the rear tires to
specifications; refer to , page .
4. Check that the blades and spindle shafts are not
bent. Refer to Checking for Bent Blades.
5. Set the height-of-cut to the 4 inch (101.6 mm)
position. Refer to Adjusting the Height-Of-Cut in ,
page .
6. Perform the steps in the following sections Frame
Set Up, Checking Front-to-Rear Pitch, and Checking
Side-to-Side Leveling.

Frame Set Up

Checking the Carrier Frame and Engine
Deck Alignment
Note: Misalignment can cause excess wear on the PTO
drive belt.
1. Disengage the PTO and set the parking brake.
2. Balancer
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Place a long straight edge on top of the engine deck
as shown in Figure 55.
4. At the carrier frame cross channel, measure the
height at location A (Figure 55). This measurement
must be 1-5/16 inch (33 mm), plus or minus a 1/4
inch (6 mm).
5. If the height at location A is not correct, adjustment
is needed.
6. Loosen the carrier frame mounting bolts on both
sides of the machine (Figure 55).
7. Align the carrier frame and engine deck to match
1-5/16 inch (33 mm), plus or minus a 1/4 inch (6
mm) at location A (Figure 55).
8. Tighten the carrier frame mounting bolts on both
sides of the machine.
1. Carrier Frame
2. Top of engine deck
3. Carrier frame mounting
bolts
Checking the Engine Deck Height
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
42
Figure 55
4. Location A, 1-5/16 inch
(33 mm) ±1/4 inch (6 mm)
5. Straight edge
6. Carrier frame cross
channel