Toro 74923TE Operator's Manual page 53

Replacing the Hydraulic Filters and
Hydraulic Oil
Service Interval: After the first 250 hours—Change the
hydraulic filters and hydraulic oil when
using any type of oil.
Every 250 hours—Change the hydraulic filters and
hydraulic oil when using Mobil
dirty or dusty conditions).
Every 500 hours—Change the hydraulic filters and
hydraulic oil when using Toro
hydraulic oil (more often in dirty or dusty conditions).
To replace the hydraulic oil, the filters need to be removed.
Replace both at the same time. Refer to the oil specifications
under Servicing the Hydraulic System (page 52) for the
correct oil.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Raise the machine and support it with jack stands
(Figure 82).
Figure 82
1. Jack stands
4. Remove both the mower belt and the pump drive
belt; refer to Replacing the Mower Belt (page 48) and
Replacing the Hydraulic Pump Drive Belt (page 49).
Note: This step will prevent oil from getting on the
belts.
5. Place a drain pan under the filter, remove the old filter
and wipe the surface clean (Figure 83).
® 1 oil (more often in
® ™
HYPR-OIL 500
53
Figure 83
Bottom View of Machine
1. Filter locations
6. Apply a thin coat of hydraulic oil to the rubber gasket
on the replacement filter (Figure 83).
7. Install the replacement hydraulic filter.
8. Install the pump drive belt and the mower belt.
9. Remove the jack stands and lower the machine
(Figure 82).
10. Add oil to the hydraulic reservoir and check for any
leaks.
11. Clean up any spilled oil.
12. Start the engine and let it run for about 2 minutes to
purge air from the system.
13. Stop the engine and check for leaks.
14. Check the oil level while the oil is cold.
15. If required, add oil to the hydraulic reservoir.
Note: Do not overfill.
1
2
G008968
2. Hydraulic filter