Toro 74923TE Operator's Manual page 30

Figure 41
1. Z Stand
2. Bracket Pin
3. Bracket
3. Raise the latch. Swing the stand foot out front and
slide stand toward machine, into the bottom of slot
(Figure 41 and Figure 42).
Figure 42
1. Z Stand (Positioned in
slot)
2. Crack in side walk or turf
4. Set the foot of stand on the ground and rest the latch
on the pivot tab (Figure 42).
5. Start the engine and put it at half throttle.
Note: For best results, place the foot of stand into
seams in sidewalks or into the turf (Figure 42).
6. Drive onto the stand. Stop when the latch drops over
the tab into the locked position (Figure 42). Once
onto the stand, engage the parking brake and tun off
the engine.
7. Chock or block the drive wheels.
WARNING
The parking brake may not hold machine
parked on Z Stand and could cause personal
injury or property damage.
Do not park on Z Stand unless wheels are
chocked or blocked.
4. Bottom of slot
5. Latch
3. Latch resting on pivot tab
Driving off the Z Stand
1. Remove the chocks or blocks.
2. Raise the latch to the unlocked position (Figure 43).
1. Z Stand
2. Latch
3. Start the engine and place it at half throttle. Disengage
the parking brake.
4. Slowly drive backwards off of the stand.
5. Return the stand to its rest position (Figure 41).
30
Figure 43
3. Locked position
4. Unlocked position