Assembly
Note: Determine the left and right sides of the snowthrower by standing in the normal operating position.
Loose Parts
DESCRIPTION
Hex bolts
Locknuts
Washers
Discharge chute
Upper handle
Knobs
Oval head bolts
Curved washers
Spring
Spring cover
Cable adjuster
Control cable
Installing the Discharge Chute
1. Position the holes on the discharge chute over the hex
bolts on the sides of the chute handle (Fig. 2).
2. Secure the discharge chute onto the hex bolts with two
washers and two locknuts (Fig. 2).
3. While holding the hex bolt heads with a 7/16-inch
(11 mm) wrench, tighten the locknuts securely.
4. Rotate the discharge chute to the upright position.
5. Install the locknut and washer tightly onto the screw at
the rear of the discharge chute (Fig. 2).
QTY.
2
2
Installing the discharge chute
2
1
1
2
Installing the handle
2
2
1
1
Installing the control cable
1
1
1
3
1. Discharge chute
2. Chute handle
3. Hex bolt
9
USE
2 4
5
m-3371
4
5
Figure 2
4. Washer
5. Locknut