Toro Snowthrower Safety - Toro CCR Powerlite 38173 Operator's Manual

Never operate the snowthrower near glass enclosures,
automobiles, window wells, drop-offs, etc. without
proper adjustment of the snow discharge angle. Keep
children and pets away.
Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
Never operate the machine at high transport speeds on
slippery surfaces. Look behind and use care when
moving in reverse.
Never direct discharge at bystanders or allow anyone
in front of the unit.
Disengage power to the collector/impeller
(auger/impeller or rotor blades) when snowthrower is
transported or not in use.
Use only attachments and accessories approved by the
manufacturer of snowthrower (Toro), such as wheel
weights, counterweights, cabs, etc. (Refer to your
Authorized Service Dealer for accessories available for
your snowthrower.)
Never operate the snowthrower without good visibility
or light. Always be sure of your footing, and keep a
firm hold on the handles. Walk; never run.
Maintenance and storage
Check all fasteners at frequent intervals for proper
tightness to be sure the equipment is in safe working
condition.
Never store the machine with fuel in the fuel tank
inside a building where ignition sources are present
such as hot water and space heaters, clothes dryers,
etc. Allow the engine to cool before storing in any
enclosure.
Always refer to this operator's manual for important
details if the snowthrower is to be stored for an
extended period.
Maintain or replace safety and instruction labels, as
necessary.
Run the machine a few minutes after throwing snow to
prevent freeze-up of the collector (auger)/impeller.
(With the engine running, pull the recoil starter handle
several times.)

Toro Snowthrower Safety

The following list contains safety information specific to
Toro products or other safety information that you must
know that is not included in the ANSI or ISO standards.
The rotating impeller/auger or rotor blades can cut
off or injure fingers or hands. Stay behind the
handles and away from the discharge opening while
operating the snowthrower. Keep your face hands,
feet, and any other part of your body or clothing
away from concealed, moving, or rotating parts.
Before adjusting, cleaning, repairing, and inspecting
the snowthrower, and before unclogging the discharge
chute, stop the engine, remove the key, and wait for
all moving parts to stop. Also, pull the wire off of
the spark plug and keep it away from the plug to
prevent someone from accidentally starting the engine.
Use a stick, not your hands to remove obstructions
from the discharge chute.
Before leaving the operator's position behind the
handles, stop the engine, remove the key, and wait for
all moving parts to stop.
Do not wear loose fitting clothing that could possibly
get caught in moving parts.
If a shield, safely device, or decal is damaged,
illegible, or lost, repair or replace it before beginning
operation. Also, tighten any loose fasteners.
Do not smoke while handling gasoline.
For two-stage snowthrowers, use the lower gear and,
for Power Shift snowthrowers, the rear wheel position
when operating on slopes.
Do not use the snowthrower on a roof.
Do not touch the engine while it is running or soon
after it is stopped because the engine will be hot
enough to cause a burn. Do not add oil or check the
oil level in the crankcase when the engine is running.
Perform only those maintenance instructions described
in this manual. Before performing any maintenance,
service, or adjustment, stop the engine, remove the key
and pull the wire from the spark plug, keeping it away
from the plug to prevent someone from accidentally
starting the engine. If major repairs are ever needed,
contact your Authorized Toro Service Dealer.
Do not over speed the engine by changing the
governor settings.
When storing the snowthrower for more than 30 days,
drain the gasoline from the fuel tank to prevent a
potential hazard. Store gasoline in a safety approved,
red container. Remove the key from the ignition
switch before storing the snowthrower.
To ensure the best performance and safety, purchase
only genuine Toro replacement parts and accessories
to keep the Toro all Toro. Do not use "Will Fit"
replacement parts and accessories as they could
cause a safety hazard.
4