Toro 30342 Operator's Manual page 37

Mid–size mower proline t–bar gear 17hp with 52in side discharge mower
Hide thumbs Also See for 30342:
Table of Contents

Advertisement

4
6
A
m–6369
Figure 51
1. Carrier Frame
2. Top of engine deck
3. Carrier frame mounting
bolts
Checking Engine Deck Height
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the tire pressure in all tires to specifications on
page 32.
4. Measure engine deck height at location A (Fig. 52).
5. Measure engine deck height at location B (Fig. 52).
6. If the height at location A and B are not the same,
change tire pressure slightly to make them the same.
3
A
4
2
Figure 52
1. Back view of machine
2. Top of engine deck
3. Tires
1
5
2
3
4. Location A, 1–5/16 inch
(33 mm) 1/4 inch (6 mm)
5. Straight edge
6. Carrier frame cross tube
3
B
1
4
m–7549
4. Same height at locations
A and B
Checking Carrier Frame Front–to–Rear
Pitch
The carrier frame must have a pitch of a 1/4 inch (6 mm)
over the length of 24 inches (61 cm) on the carrier frame
(Fig. 53).
1. Measure out 24 inches (61cm) on the carrier frame
(Fig. 53).
2. Measure carrier frame height at location A (Fig. 53).
3. Measure carrier frame height at location B (Fig. 53).
4. The height at location A must be a 1/4–3/8 inch
(6 mm –10 mm) lower than location B (Fig. 53).
5. If the carrier frame is not correct, move caster spacers
to make it a 1/4–3/8 inch (6 –10 mm) pitch (Fig. 53).
Move spacers from top or bottom to make the correct
pitch.
6. The tire pressure may also be adjusted slightly to make
a 1/4 inch (6 mm) pitch.
5
3
5
A
1
1. Caster Wheel
2. Carrier Frame
3. 1/4–3/8 inch
(6 mm–10 mm) pitch over
24 inch (61 cm) length
Checking Carrier Frame Side–to–Side
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the tire pressure in all tires to specifications on
page 32.
4. Measure carrier frame height at location A (Fig. 54).
5. Measure carrier frame height at location B (Fig. 54).
37
24 inch
(61cm)
B
4
2
4
Figure 53
4. Height at locations A
and B
5. Caster spacers
m–6370

Advertisement

Table of Contents
loading

Table of Contents