Toro 30342 Operator's Manual page 25

6
1
3
Figure 26
1. Control rod and fitting
2. Idler bracket
3. Clevis pin
2. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing handle to rear frame (Fig. 27).
4
6
1
3
7
8
Figure 27
1. Upper handle
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
3. Remove the lower flange bolts (3/8 x 1 inch) and flange
nuts securing handle to rear frame (Fig. 27).
4. Pivot handle to desired operating position and install
lower flange bolts (3/8 x 1 inch) and flange nuts into
mounting holes. Tighten all flange bolts.
5. Thread rod fitting up or down on rod until proper
position is attained and install into fitting to idler
bracket with clevis pin, washer and hairpin cotter. Refer
to Installing the Control Rods, page 16.
6. Check the parking brake adjustment. Refer to Checking
the Brakes, page 32.
4
5
2
m–7593
4. Washer
5. Hairpin cotter pin
6. Rod fitting
5
2
m–6403
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
25