Onkyo DV-SP305 Instruction Manual page 54

Troubleshooting—Continued
Buttons on the
DV-SP305 work OK but
those on the remote
controller don't?
Note:
• Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplug the power
cord and then plug back in. This will usually reset the unit for proper operation. If this does not correct the problem,
please consult your nearest our customer center.
The DV-SP305 contains a microcomputer for signal processing and control functions. In very rare situations, severe
interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this
should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
54
There are no batteries in the remote
controller.
The batteries are flat.
The batteries are installed incorrectly.
You're not pointing the remote controller
at the DV-SP305's remote sensor.
You're too far away from the DV-SP305.
A strong light source is interfering with
the DV-SP305's remote sensor.
If the DV-SP305 is installed in a cabinet
with colored glass doors, the remote con-
troller may not work reliably when the
doors are closed.
Install new batteries (page 10).
Replace with new batteries (page 10).
Check the batteries and correct as necessary
(page 10).
Point the remote controller at the DV-SP305's
remote sensor (page 10).
Use the remote controller closer to the DV-SP305
(page 10). The remote controller has a range of
approximately 5 meters.
Make sure that the DV-SP305 is not subjected to
direct sunshine or inverter-type fluorescent lights.
Relocate if necessary.
Open the doors, or use a cabinet without colored
glass.