Table of Contents
Advertisement
Setup
1
Installing the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Loosen the handle knobs (Figure 3).
Important: Route the cables to the outside of the
handle as you install the handle.
1. Handle knob (2)
2. Move the handle to the operating position (Figure 4).
3. Tighten the handle knobs firmly by hand (Figure 3).
Figure 3
Figure 4
2
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: You must install the recoil-starter rope in
the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 5).
1. Recoil-starter rope
3
Filling the Engine with Oil
No Parts Required
Procedure
Important: This machine does not come with oil in the
engine. Before starting the engine, fill the engine with
oil.
1. Move the machine to a level surface.
2. Remove the dipstick (Figure 6) and pour about 3/4 of
the crankcase capacity of oil into the oil-fill tube.
Note: Max. fill: 0.59 L (20 oz), type: SAE 30 or SAE
10W-30 detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.
5
Figure 5
2. Rope guide
Advertisement
Table of Contents
