Figure 6
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in.
5. Remove the dipstick and read the oil level on the
dipstick (Figure 7).
•
If the oil level is too low, slowly pour a small
amount of oil into the oil-fill tube, wait 3 minutes,
and then repeat steps 3 through 5 until the oil level
is correct.
•
If the oil level is too high, drain the excess oil until
the oil level is correct. To drain the excess oil, refer
to Changing the Engine Oil (page 13).
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
Figure 7
1. Oil level is too low
2. Oil level is too high
6. Install the dipstick into the oil-fill tube securely.
Important: Change the engine oil after the first 5
operating hours ; change it yearly thereafter; refer
to Changing the Engine Oil (page 13).
3. Oil level is correct
Product Overview
1. Spark plug
2. Oil fill/dipstick (not shown)
3. Recoil-start handle
4. Blade-control bar
5. Self-propel drive bar
1. Rear-discharge deflector (optional attachment; Toro part
89964)
Specifications
Model
Weight
29639
34 kg
(75 lb)
6
Figure 8
6. Grass bag
7. Fuel-tank cap
8. Cutting-height levers (4)
9. Air filter
Figure 9
Length
Width
Height
144 cm
54 cm
(57 inches)
(21 inches)
(39 inches)
145 cm