Adjusting The Starter Generator Belt; Cleaning; Washing The Vehicle - Toro 07264 Operator's Manual

1. Park the machine on a level surface, shift into
Neutral, set the parking brake, turn the ignition
off, and remove the key.
2. Raise the bed and secure it with the prop rod.
3. Rotate and inspect the belt (Figure 52) for
excessive wear or damage. Replace the belt if
necessary.
Figure 52
1. Drive belt
2. Primary clutch
Replacing the Drive Belt
1. Rotate and route the belt over the secondary
clutch (Figure 52).
2. Remove the belt from the primary clutch
(Figure 52).
3. To replace the belt, reverse the procedure.
Adjusting the Starter
Generator Belt
Check the tension of the starter generator belt after
the first day of operation and every 200 operating
hours thereafter.
1. Park the machine on a level surface, set the
parking brake, turn the ignition off, and
remove the key.
2. Loosen the starter generator pivot bolt
(Figure 53).
3. Secondary clutch
Figure 53
1. Generator pivot bolt
3. Wedge a pry bar between the engine mount
and starter. Loosen the nut on the adjusting
carriage bolt (Figure 53).
4. Tilt the starter in the slot until the belt flexes
1/4 inch (6 mm) with 10 lb (44.5 N) of force.
5. Tighten the carriage bolt nut and remove the
pry bar. Tighten the starter generator pivot
bolt (Figure 53).

Cleaning

Washing the Vehicle

The vehicle should be washed as needed. Use
water alone or with a mild detergent. A rag may
be used, however the hood will loose some of its
luster.
Important: Pressurized water is not
recommended when washing the machine.
It may damage the electrical system, loosen
important decals, or wash away necessary
grease at friction points. Avoid excessive use
of water, especially near the control panel,
engine, and battery.
42
2. Adjusting carriage bolt