Gear Shift Selector; Ignition Switch; Hour Meter; Oil Light - Toro 07253TC Operator's Manual

Gear Shift Selector

The gear shift selector moves the vehicle in the
desired direction forward or reverse (Fig. 5). The
vehicle will start in either direction.
Note: If the gear shift selector is in REVERSE
when the ignition is turned on, a buzzer will sound to
warn the operator.the
IMPORTANT: The vehicle should always be
stopped before changing the gear selection and
direction.

Ignition Switch

The ignition switch (Fig. 6), used to start and stop the
engine, has two positions: OFF and ON. Turn the key
clockwise-ON position-to allow operation. When the
vehicle is stopped, turn the key counterclockwise to
THE OFF position. Remove the key from the
ignition.

Hour Meter

The hour meter (Fig. 6) indicates the total number of
hours the engine is running. The hour meter starts to
function whenever the accelerator is depressed.

Oil Light

The oil light warns the operator if the engine oil
pressure drops below a safe level (Fig. 6). If the light
comes on, the oil level should be checked and oil
added if necessary; see Engine Oil in the
Maintenance section.

Light Switch

Toggle switch to activate headlights. Push to turn
lights "ON" (Fig. 6).

Power Point

The power point is used to power optional electrical
accessories (Fig. 6).
Operation
1. Ignition switch
2. Hour meter
3. Light switch
4. Oil light
5. Power point

Fuel Gauge

The fuel gauge (Fig. 7) shows amount of fuel in the
tank.
1. Fuel gauge

Passenger Hand Holds

The passenger hand holds are located on the right
side of the dash panel and at the outside of each seat
(Fig. 8).
– 15 –
Figure 6
Figure 7