Product Overview; Specifications - Toro Recycler 20954 Operator's Manual

Figure 5
1. Dipstick
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick fully into the oil-fill tube.
5. Remove the dipstick and read the oil level on the
dipstick; refer to Figure 5.
•
If the oil is below the Add mark on the dipstick,
slowly pour a small amount of oil into the oil-fill
tube, wait 3 minutes, and then repeat steps 3
through 5 until the oil level is at the Full mark on
the dipstick.
•
If the oil is above the Full mark on the dipstick,
drain the excess oil until the oil level is at the Full
mark on the dipstick. To drain the excess oil, refer
to Changing the Engine Oil (page 13).
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick into the oil-fill tube securely.
Important: Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to Changing the Engine Oil (page 13).

Product Overview

1. Cutting-height lever (4)
2. Spark plug
3. Air filter (not shown)
4. Fuel-tank cap
5. Oil fill/dipstick
6. Handle
1. Grass bag

Specifications

Model Weight
20954 37 kg
(81 lb)
6
Figure 6
7. Recoil-start handle
8. Blade-control bar
9. Self-propel-drive bar
10. Handle knob (2)
11. Washout port
Figure 7
2. Side-discharge chute
Length Width Height
150 cm 58 cm
(59 in) (23 in)
107 cm
(42 in)