Installing The Handle Assembly - Toro 38086 Operator's Manual

DESCRIPTION
Skids
Flange-head bolts—3/4 in. (1.9 cm)
Flat washers and locknuts
Ignition key

Installing the Handle Assembly

1. Remove the tie straps that secure the control rods to the
handle assembly.
2. Remove the axle pins from both wheels (Fig. 2) and
slide the wheels outward on the axle approximately one
inch (2.5 centimeters).
Figure 2
1. Axle pin (2)
2. Bolts and curved
washers (4)
3. Hold the left side of the handle assembly in the
installation position and insert the upper traction rod
through the loop in the lower traction rod (Fig. 3).
QTY.
653
3. Handle assembly
2
2 Installing the skids
2
1 Starting and stopping the engine
Figure 3
1. Lower traction rod
Important
Ensure that the chute control rod
assembly is between the engine and the traction rod
(Fig. 4).
Figure 4
1. Engine
2. Chute control rod
4. Position the left side of the handle assembly against the
left side of the snowthrower, align the handle mount
holes with the holes in the side plate, and secure the left
side of the handle assembly with two bolts and curved
washers until they are finger tight (Fig. 2).
9
USE
m-2669
2. Upper traction rod
m-2665
3. Traction rod
4. Side plate