Assembly; Loose Parts; Installing The Handle Assembly - Toro 38053 Operator's Manual

Assembly

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

DESCRIPTION
Handle assembly
Bolts
Curved washers
Speed selector rod
Cotter pin
Flat washer
Spring
Flange locknut
Lower link
Flange nut
Flange locknut
Discharge chute
Chute control rod assembly (Rod and bracket,
worm gear, and bracket)
Bolt, pyramidal washer, and locknut
Bolt
Locknut
Ignition key

Installing the Handle Assembly

1. Remove the tie straps that secure the control rods to the
handle assembly.
2. Remove the axle pins from both wheels (Fig. 3) and
slide the wheels outward on the axle approximately one
inch (2.5 centimeters).
QTY.
1
4
Installing the handle assembly g
4
1
1
Installing the speed selector rod g
1
1
Installing the traction rod Installing the traction rod
1
1
1 Installing the auger/impeller drive control
linkage
1
1 Installing the discharge chute
1
1 Installing the chute control rod
1
1
1 Starting and stopping the engine
1. Axle pin (2)
2. Bolts and curved
washers (4)
8
USE
y
653
Figure 3
3. Handle assembly