System Connection - Bush DVD9957BUK User Manual

System Connection

Powering and installation
Plug one end of the AC/DC power adaptor into the DC IN 9-12V jack on the right of the
main unit, then plug the other end into the AC power receptacle. Please refer to the
following illustration.
AV OUT
If using car cigarette lighter adaptor to connect to the power:
Plug one end of the cigarette lighter adaptor into the DC IN 9-12V jack on the unit, plug
the other end into the car cigarette lighter socket. See illustration below.
AV OUT
Note
Car cigarette lighter adaptor is available to use only when the car cigarette lighter with DC
12V negative grounding.
The mains plug is used as the disconnect device, the disconnect device should remain
readily operable.
Using SD/MMC card
Upon using an SD or MMC card, insert it into the corresponding slot flatly with the label
side frontward until you hear a click.
Using USB
Upon using an USB, insert it into the USB slot directly.
DC OUT
DC OUT
AV OUT DC OUT
AV OUT DC OUT
4
Connecting to the monitor
The unit can also be connected to the external LCD monitor.
Connect the unit to power by AC/DC adapter or cigarette lighter adapter.
Then connect the unit DC OUT jack to DC IN 9-12V Jack of the LCD Monitor by a DC/AV
cable. Also use this DC/AV cable to connect the AV OUT jack of the unit to AV IN
jack of the Monitor.
Please refer to the illustration below.
Note: You're advised to supply both units the power by the cigarette lighter adapter
only. The AC/DC adapter is used to supply power of one unit only and as the charger
to charge the main unit if it's with built-in battery.
AV OUT DC OUT
5