Toro 74919TE Operator's Manual page 29

Hide thumbs Also See for 74919TE:
Table of Contents

Advertisement

1. Back the machine up the
ramps.
Important: Do not use narrow individual ramps for
each side of the machine.
Ensure that the ramp is long enough so that the angle with
the ground does not exceed 15 degrees
ground, this requires a ramp to be at least 4 times as long as
the height of the trailer or truck bed to the ground. A steeper
angle may cause mower components to get caught as the
machine moves from the ramp to the trailer or truck. Steeper
angles may also cause the machine to tip or lose control. If
you are loading the machine on or near a slope, position the
trailer or truck so that it is on the down side of the slope and
the ramp extends up the slope. This minimizes the ramp
angle.
WARNING
Loading a machine onto a trailer or truck increases
the possibility of a tip-over and could cause serious
injury or death.
• Use extreme caution when operating a machine
on a ramp.
• Ensure that the ROPS is in the up position and
use the seat belt when loading or unloading the
machine. Ensure that the ROPS clears the top
of an enclosed trailer.
• Use only a full-width ramp; do not use individual
ramps for each side of the machine.
• Do not exceed a 15-degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
• Ensure that the length of ramp is at least 4 times
as long as the height of the trailer or truck bed to
the ground. This ensures that ramp angle does
not exceed 15 degrees on flat ground.
• Back the machine up the ramps and drive it
forward down the ramps.
• Avoid sudden acceleration or deceleration while
driving the machine on a ramp as this could
cause a loss of control or a tip-over.
Figure 38
2. Drive the machine forward
down the ramps.
(Figure
39). On flat
g028043
6
1. Full-width ramp in stowed
position
2. Side view of full-width
ramp in loading position
3. Not greater than
15 degrees
29
1
2
5
Figure 39
4. The ramp is at least 4
times as long as the height
of the trailer or truck bed
to the ground.
5. H= height of the trailer or
truck bed to the ground
6. Trailer
g027996

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z master professional 6000 series74925te

Table of Contents