Toro 74919TE Operator's Manual page 60

Figure 94
1. 7.6 cm (3 inches) at
position A is correct
2. 8.3 cm (3-1/4 inches) at
position B is correct
10. Fine-tune the adjustment nut on the front deck-lift
assembly by turning it
Note: To increase the height, turn the adjustment
nut clockwise; to decrease the height, turn the nut
counterclockwise.
2
1
g027344
Figure 95
1. Adjustment nut
2. Jam nut
11. For mower decks shown in
adjustment nut on the front deck-lift assembly by
turning it (Figure 96).
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure 95).
3 4
2 1
3. Rear deck adjustment
4. Front deck adjustment
Figure 96, fine-tune the
Note: To increase the height, turn the adjustment
nut clockwise; to decrease the height, turn the nut
counterclockwise.
Note: If the front deck links do not have enough
adjustment to achieve accurate cut height, you can
utilize the single-point adjustment to gain more
adjustment.
1. Adjustment nut
2. Jam nut
12. To adjust the single-point system, loosen the 2 bolts at
the bottom of the height-of-cut plate
1. Bolts at the bottom of the height-of-cut plate
60
Figure 96
3. Rear deck adjustment
4. Front deck adjustment
(Figure
Figure 97
97).