Adjusting The Height Of Cut; Positioning The Seat; Adjusting The Motion Control - Toro 74402 Operator's Manual

Children or bystanders may be injured if they
move or attempt to operate the mower while it
is unattended.
Always remove the ignition key and move the
motion control levers to the brake position when
leaving the machine unattended, even if just for
a few minutes.

Adjusting the Height of Cut

The height of cut is adjusted from 1-1/2 to 4-1/2 inch
(38 to 114 mm) in 1/2 inch (13 mm) increments by
moving the height-of-cut lever in different locations.
1. Raise the height-of-cut lever to the transport
position (also the 4-1/2 inch (114 mm) cutting
height position (Figure 12 ).
2. To adjust, pull up on the height-of-cut lever and
move it to the desired position (Figure 12 ).
Figure 12
1. Height-of-cut lever

Positioning the Seat

The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
1. Raise the seat and loosen the adjustment knobs
enough to move the seat (Figure 13 ).
2. Height-of-cut positions
Important: Make sure that the spacers stay
in place when loosening the knobs to move the
seat. Loss of the spacers can result in damage
to the seat.
2. Move the seat to the desired position and tighten
the knobs.
Figure 13
1. Adjustment knobs
Adjusting the Motion
Control Levers
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 14 ).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 14 ).
17