Table of Contents
Advertisement
Side Discharging the
Clippings
Use the side discharge for cutting very tall grass.
Important: Ensure that
the rear discharge plug
is in place before you
side discharge the
clippings.
Installing the Side Discharge Chute
1. Unlock the
side discharge
door.
2. Lift open the side
discharge door.
3. Install the side discharge chute and close the
door onto the chute.
Removing the Side Discharge Chute
To remove the side discharge chute, reverse the
steps above.
Important: Lock
the side discharge
door after you
close it.
8
Operating Tips
Clear the area of sticks, stones, wire, branches,
and other debris that the blade could hit.
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
If the mower strikes an object or starts to vibrate,
immediately stop the engine, disconnect the wire
from the spark plug, and examine the mower for
damage.
For best performance, install a new blade before
the cutting season begins.
m-5587
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
Cut only about a third of the grass blade at a
time. Do not cut below the 2-inch (51 mm) setting
unless the grass is sparse or it is late fall when
grass growth begins to slow down. Refer to
Adjusting the Cutting Height on page 6.
When cutting grass over 6 inches (15 cm) tall,
mow at the highest cutting height setting and walk
slower; then mow again at a lower setting for the
best lawn appearance. If the grass is too long, the
mower may plug and cause the engine to stall.
Mow only dry grass or leaves. Wet grass and
leaves tend to clump on the yard and can cause
m-5584
the mower to plug or the engine to stall.
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Mow only in dry
conditions.
Alternate the mowing direction. This helps
disperse the clippings over the lawn for even
fertilization.
If the finished lawn appearance is unsatisfactory, try
m-5585
one or more of the following:
Replace the blade or have it sharpened.
Walk at a slower pace while mowing.
Raise the cutting height on your mower.
Cut the grass more frequently.
Overlap cutting swaths instead of cutting a full
swath with each pass.
Set the cutting height on the front wheels one
notch lower than the rear wheels. For example,
set the front wheels at 2 inches (51 mm) and the
rear wheels at 2-3/8 inches (60 mm).
3350-949
Warning
Advertisement
Table of Contents
