Headlights; Positioning The Tilt Steering Wheel; Pushing The Machine By Hand - Toro 72200 Operator's Manual

Headlights

The headlights are turned on with a separate position,
lights, of the ignition switch (Fig. 12). The lights are on
while the ignition switch is in the lights position even with
the engine off. Remove the key when the machine is left
unattended so lights can not be turned or discharging the
battery.
Figure 12
1. Lights
Positioning the Tilt Steering
Wheel
The steering wheel has four tilt locations. Position the
steering wheel where you have the best control of the
machine and are most comfortable.
1. Lift the tilt lever to release the lock (Fig. 13).
2. Move the steering wheel to a comfortable position;
then release the lever to lock.
1
Figure 13
1. Tilt lever

Pushing the Machine by Hand

Important Always push the machine by hand. Never
tow the machine because transaxle damage may occur.
1
1208
2
1203b
2. Steering wheel
20
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off.
2. Move the drive control rod to the push position. This
disengages the drive system and allows the wheels to
turn freely (Fig. 14).
To Operate the Machine
1. Move the drive control rod to the operate position
(Fig. 14).
Note: The machine will not drive unless the drive control
rod is in the operate position.
1
2
Figure 14
1. Operate position
2. Push position
3
M–4566
3. Drive control rod