Rear Panel - Onkyo CR-515 CR-315 Instruction Manual

Rear Panel

CR-515 1
LINE 1
IN
OUT
MD/
TAPE
IN
OUT
DOCK/
CDR
IN
R
8 9
CR-315
DOCK
K
I N
OUT
MD/
TAPE
IN
R
The page numbers in parentheses show where you can find the main explanation for each item.
A
LINE 1 IN (CR-515) (25)
This analog audio input is for connecting a compo-
nent with an analog output, such as a TV, or a turn-
table with a built-in phono equalizer.
B
MD/TAPE IN/OUT (20, 21)
These analog audio inputs and outputs are for con-
necting a recorder with an analog input and output,
such as a MiniDisc recorder or cassette deck.
C
DOCK/CDR IN/OUT (CR-515) (22, 23)
These analog audio inputs and outputs are for con-
necting a recorder with an analog input and output
such as a CD recorder, or an Onkyo RI Dock.
D
AM ANTENNA (16, 17)
These push terminals are for connecting an AM
antenna.
E
FM ANTENNA (16, 17)
This jack is for connecting an FM antenna.
F
SUBWOOFER PRE OUT (19)
This jack is for connecting a powered subwoofer.
G
SPEAKERS (18)
These terminal posts are for connecting speakers.
The North American CR-315 has push-type termi-
nals.
Getting to Know the CD Receiver—Continued
2 3 4
L
L
5 6
AC INLET
H
REMOTE CONTROL (20–24)
This (Remote Interactive) jack can be con-
nected to an jack on another Onkyo component.
The CD receiver's remote controller can then be
used to control that component. To use
must make an analog audio connection (RCA)
between the CD receiver and the other component,
even if they are connected digitally.
I
OPTICAL DIGITAL IN (CR-515 Asian model
only) (24)
This optical digital audio input can be used to con-
nect a component with an optical digital output,
such as a CD recorder, MD recorder, games con-
sole, satellite tuner, or personal computer. Use a
commercially available optical digital audio cable to
make the connection.
J
AC INLET (25)
The supplied power cord is connected here.
K
DOCK IN (CR-315) (22)
This analog audio input is for connecting an Onkyo
RI Dock.
See pages 16–25 for connection information.
7
J
, you
11