Toro 30626 Operator's Manual page 17

in kit (Fig. 6). Install manual tube into R-clamps and
tighten capscrews (Figure 7).
1. R-clamps
2. Seat support
2. Mount seat pivot bracket to frame with 2 flange
screws supplied in kit (Figure 8).
1
1. Seat pivot bracket
3. Mount seat and seat support to seat pivot bracket
with pivot shaft and roll pin (Figure 9).
1. Pivot shaft
4. Hold seat up with seat support rod (Figure 10).
Figure 7
3. Manual tube
4. Cap
G005684
Figure 8
Figure 9
2. Roll pin
1. Seat support rod
5. Plug wire harness connector into seat switch
connector on bottom of seat.
6. Disengage seat support rod and pivot downward.
Pivot seat down and push lynch pin through seat
latch stud. Flip wire end of pin over latch stud
(Figure 11).
1. Lynch pin
7. Slide seat completely forward and backward to
ensure proper operation and that seat switch wires
and connectors are not pinched or do no contact any
moving parts.
17
Figure 10
Figure 11