Toro GTS 200 Service Manual page 25

Remove Flywheel Brake
1. Disconnect spark plug lead from spark plug.
2. Remove static guard and fuel tank, Fig. 36.
1
2
Fig. 36 – Removing Static Guard and Fuel Tank
1. Static guard
2. Fuel tank
3. Remove dipstick and oil fill tube, Fig. 37.
4. Remove blower housing and rewind starter, Fig. 37.
2
1
Fig. 37 – Removing Dipstick and Oil Fill Tube,
Blower Housing and Rewind Starter
1. Screw
2. Blower housing and
rewind starter
5. Disconnect spring from brake anchor.
6. Disconnect stop switch wire from stop switch. If engine is
equipped with electric starter, disconnect both wires from
starter interlock switch.
GTS 200
3
2
3
3. Screw
1
3
4
3. Dipstick screw
4. Dipstick and oil fill tube
7. Remove two screws from brake bracket and remove
bracket, Fig. 38.
1
7
Fig. 38 – Removing Brake Bracket
1. Stop switch wire
2. Screw
3. Anchor
4. Brake bracket
Inspect Flywheel Brake and Switches
1. Inspect brake lining on brake lever. Replace brake
assembly if lining is less than .090" (2.28mm) thick.
2. Test stop switch as described in the section General
Information, stop switch – remote control.
3. Test electric starter interlock switch as described in the
section Electric Starter, Check Interlock Switch.
Assemble Flywheel Brake
1. Install brake assembly on crankcase and torque mounting
screws to 40 in. lbs. (5.0Nm) Fig. 38.
2. Install stop switch wire and bend end of wire 90 . Install
interlock switch wires on interlock switch, if used, Fig. 38.
3. Install blower housing as described on page 37, "Install
Blower Housing and Rewind Starter."
4. Install dipstick tube and dipstick.
5. Install fuel tank and static guard.
Governor Controls, Carburetor Linkage,
23
8 2
3
6
5
5. Starter interlock switch
wires
6. Brake spring
7. Brake lever
8. Brake pad
and Flywheel Brake
4