Table of Contents
Advertisement
4. Place fiber washer over main jet and install main jet.
Torque nut to 50 in. lbs. (6.0Nm), Fig. 29.
1
Fig. 29 – Installing Float, Hinge Pin and
Inlet Needle
1. Float
2. Hinge pin
High Altitude Compensation
Note: If engine is operated at high altitudes, performance may
decrease. If poor performance is experienced refer to the
proper Toro parts manual for replacement high altitude main
jet.
Install Carburetor
1. Hook governor link into grommet on throttle lever from
the top, Fig. 30.
Fig. 30 – Install Carburetor
2. Place new intake gasket on throttle side of carburetor,
Fig. 31.
3. Using carburetor mounting screws to align parts, place
carburetor on control bracket, Fig. 31.
4. Install carburetor assembly with two (2) mounting screws
torquing screws to 80 in. lbs
GTS 200
2
3
3. Inlet needle
.
(10.0Nm), Fig. 31.
5
6
1
Fig. 31 – Installing Carburetor
1. Mounting screw
2. Carburetor
3. Carburetor control bracket
4. Gasket
Install Air Cleaner
1. Install breather tube on air cleaner primer base and position
base with new gasket on carburetor mounting surface.
2. Install air cleaner primer base with two (2) screws into
carburetor.
3. Torque two (2) carburetor mounting screws to 30 in. lbs.
(3.0Nm), Fig. 32.
3
5
Fig. 32 – Installing Intake Elbow Assembly
1. 2 screws
2. Cover
3. Pre-cleaner
4. Install air cleaner cartridge and pre-cleaner, Fig. 32.
5. Install air cleaner cover and two (2) screws, tighten screw
farthest from spark plug first.
21
3
1
2
1
5. Current style, mounting
hole
6. Early style
1
4
Ô Ô Ô
Ô Ô Ô
4. Cartridge
5. Base
Carburetion
4
2
m–3664
Advertisement
Chapters
Table of Contents
