Table of Contents
Advertisement
3
2
1
Figure 12
1. Hairpin cotter
2. Unused spacers
Step
7
Checking the Tire Pressure
Parts needed for this step:
None
Procedure
Refer to page 38 for the correct correct tire pressure.
m-6505
3. Height–of–cut post (front
shown)
20
Step
8
Activating the Battery
Parts needed for this step:
Qty.
80
Bulk electrolyte with 1.265 specific gravity
ounces
(Purchase from a battery supply outlet.)
Procedure
Bulk electrolyte with 1.265 specific gravity must be
purchased from a local battery supply outlet.
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Danger
Battery electrolyte contains sulfuric acid which is
a deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and robber gloves to protect
your hands.
•
Fill the battery where clean water is always
available for flushing the skin.
•
Follow all instructions and comply with all
safety messages on the electrolyte container.
1. Remove the battery from the machine. Refer to
Removing the Battery on page 35.
Part
Advertisement
Table of Contents
