Toro Riding Mower Safety - Toro 74704 Operator's Manual

Hide thumbs Also See for 74704:
Table of Contents

Advertisement

• Never allow children or others in or on towed
equipment.
• On slopes, the weight of towed equipment may cause a
loss of traction and control. Towing on slopes is not
recommended.
• Travel slowly and allow extra distance to stop.
Service
Safe Handling of Gasoline:
To avoid personal injury or property damage, use extra care
when handling gasoline and other fuels. They are
flammable and the vapors are explosive.
• Extinguish all cigarettes, cigars, pipes and other sources
of ignition.
• Use only an approved container.
• Never remove the gas cap or add fuel when the engine
is running. Allow the engine to cool before refueling.
• Never refuel the machine indoors.
• Never store the machine or fuel container inside where
there is an open flame, such as near a water heater or
furnace.
• Never fill containers inside a vehicle or on a truck or
trailer with a plastic liner. Always place containers on
the ground away from your vehicle before filling.
• Remove gas-powered equipment from the truck or
trailer and refuel it on the ground. If this is not possible,
then refuel such equipment with a portable container,
rather than from a gasoline dispenser nozzle.
• Keep the nozzle in contact with the rim of the fuel tank
or container opening at all times until the fueling is
complete. Do not use a nozzle lock-open device.
• If fuel is spilled on clothing, change clothing
immediately.
• Never overfill the fuel tank. Replace gas cap and tighten
securely.
General Service:
• Never run a machine inside a closed area.
• Keep nuts and bolts tight, especially the blade
attachment bolts. Keep equipment in good condition.
• Never tamper with safety devices. Check their proper
operation regularly.
• Keep the machine free of grass, leaves, or other debris
build-up. Clean up oil or fuel spillage fuel soaked
debris. Allow the machine to cool before storing.
• Stop and inspect the equipment if you strike an object.
Repair, if necessary, before restarting.
• Never make any adjustments or repairs with the engine
running.
• Grass catcher components are subject to wear, damage
and deterioration, which could expose moving parts or
allow objects to be thrown. Frequently check
components and replace with manufacturer's
recommended parts, when necessary.
• Mower blades are sharp and can cut. Wrap the blade(s)
or wear gloves, and use extra caution when servicing
them.
• Check for proper brake operation frequently. Adjust and
service as required.
• Maintain or replace safety and instruction decals as
necessary.
• Use only genuine Toro replacement parts to ensure that
original standards are maintained.

Toro Riding Mower Safety

The following list contains safety information specific to
Toro products or other safety information that you must
know that is not included in the ANSI standards.
• Do not mow slopes greater than 15 degrees.
• Engine exhaust contains carbon monoxide, which is an
odorless, deadly poison that can kill you. Do not run
engine indoors or in an enclosed area.
• Stop the engine, disconnect spark plug wire(s) and
remove key before performing any service, repairs,
maintenance or adjustments.
• Keep hands, feet, hair, and loose clothing away from
attachment discharge area, underside of mower and any
moving parts while engine is running.
• Do not touch equipment or attachment parts which may
be hot from operation. Allow to cool before attempting
to maintain, adjust or service.
• Battery acid is poisonous and can cause burns. Avoid
contact with skin, eyes, and clothing. Protect your face,
eyes, and clothing when working with a battery.
• Battery gases can explode. Keep cigarettes, sparks and
flames away from battery.
• Use only Toro approved attachments. Warranty may be
voided if used with unapproved attachments.
• If loading the machine onto a trailer or truck, use a
single, full-width ramp only. The ramp angle should not
exceed 15 degrees.
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zx480 timecutter

Table of Contents