Servicing The Air Cleaner - Toro 74704 Operator's Manual

Hide thumbs Also See for 74704:
Table of Contents

Advertisement

1
Figure 18
1. Oil drain valve
9. Change the oil filter, if necessary (Fig. 19).
10. Clean around the oil dipstick and unscrew the cap
(Fig. 16).
11. Slowly pour approximately 80% of the specified oil into
the filler tube (Fig. 16). Refer to Servicing the Engine
Oil, page 21.
12. Check the oil level; refer to Checking the Oil Level,
page 21.
13. Slowly add additional oil to bring it to the full mark.
Changing the Oil Filter
Replace the oil filter every 100 hours or every other oil
change.
Note: Change the oil filter more frequently when operating
conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to Changing and
Draining the Oil, page 21.
2. Remove the old filter and wipe the filter adapter gasket
surface (Fig. 19).
3. Apply a thin coat of clean oil to the rubber gasket on the
replacement filter (Fig. 19).
1
Figure 19
1. Oil filter
2. Gasket
2
m–6438
2. Oil drain tube
3
2
1256
3. Adapter
22
4. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter; then tighten the filter an
additional 1/2 to 3/4 turn (Fig. 19).
5. Fill the crankcase with the proper type of new oil; refer
to Changing and Draining the Oil, page 21.

Servicing the Air Cleaner

Foam Element: Clean after every 25 operating hours, or
yearly, whichever occurs first.
Paper Element: Replace after every 100 operating hours or
yearly, whichever occurs first.
Note: Service the air cleaner more frequently (every few
hours) if operating conditions are extremely dusty or sandy.
Removing the Foam and Paper Elements
1. Park the machine on a level surface and disengage the
blade control (PTO).
2. Move the motion control levers to the brake position,
stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Clean around the air cleaner to prevent dirt from getting
into the engine and causing damage. Remove the air
cleaner cover knobs (Fig. 20) and lift up the cover.
Remove the air cleaner cover.
2
2
Figure 20
1. Air cleaner cover
1
1
2. Air cleaner cover knob

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zx480 timecutter

Table of Contents