Makita GV7000C Instruction Manual page 5

Refer to the table for the relationship between the
number settings on the dial and the approximate tool
speed.
Number
1
l
2
l
3
l
4
l
5
006385
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded and
heated up.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or
the speed adjusting function may no longer work.
The tools equipped with electronic function are easy to
operate because of the following features.
Constant speed control (GV7000C only)
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the rotating speed is
kept constant even under load condition.
Soft start feature (GV7000C only)
Safety and soft start because of suppressed starting
shock.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (auxiliary handle) & cover
1
2
003412
RPM (/min)
2,500
l
2,800
l
3,500
l
4,200
l
4,700
1. Cover
2. Side grip
5
1
2
003413
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Install the cover, then screw the side grip on the tool
securely. The side grip and the cover can be installed on
either side of the tool.
Installing or removing abrasive disc
1
2
3
003414
Mount the rubber pad onto the spindle. Fit the abrasive
disc on the rubber pad and screw the lock nut onto the
spindle.
To tighten the lock nut, hold the spindle with the wrench
so that it cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
003418
To remove the disc, follow the installation procedure in
reverse.
1. Cover
2. Side grip
1. Lock nut
2. Abrasive disc
3. Rubber pad
4. Spindle
4
1. Lock nut wrench
2. Wrench
2