Operating The Power Take Off (Pto) - Toro 74236 Operator's Manual

6. Turn the ignition key to Start to energize the starter.
When the engine starts, release the key (Fig. 16).
Important
Do not engage the starter for more than 10
seconds at a time. If the engine fails to start, allow a 30
second cool-down period between attempts. Failure to
follow these instructions can burn out the starter motor.
7. After the engine starts, move the choke to Off (Fig. 14).
If the engine stalls or hesitates, move the choke back to
On for a few seconds. Then move the throttle lever to
the desired setting. Repeat this as required.
2
1
m–4201
Figure 13
1. PTO—On
2. PTO—Off
1
2
m–2720
Figure 15
1. Throttle—Fast
2. Throttle—Slow
Stopping the Engine
1. Push the PTO to off (Fig. 15).
2. Move the throttle lever midway between the slow and
fast positions (Fig. 15).
3. Let the engine idle for 60 seconds (Fig. 16).
4. Turn the ignition key to off (Fig. 16).
2
1
m–2719
Figure 14
1. Choke—On
2. Choke—Off
1
2
3
M–4268
Figure 16
1. Off
2. Run
3. Start
20
5. Pull wire off spark plug(s) to prevent possibility of
someone accidentally starting the machine before
transporting or storing machine.
6. Close fuel shut off valve, on front panel before
transporting or storing machine.
Important
Make sure that the fuel shut off valve is
closed before transporting or storing the machine, as fuel
leakage may occur. Set the parking brake before
transporting. Make sure to remove the key as the fuel pump
may run and cause the battery to lose charge.
Caution
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Operating the Power Take Off
(PTO)
The power take off (PTO) switch engages and disengages
power to the electric clutch.
Engaging the PTO
1. While seated in the seat, release the pressure on the
traction control levers and place in neutral.
2. Place the throttle in the fast position.
3. Pull out on the power take off (PTO) switch to engage it
(Fig. 17).
1
Figure 17
1. PTO—Off
Disengaging the PTO
To disengage, push the PTO switch to the Off position
(Fig. 17).
2
m–4201
2. PTO—On