Toro 74902TE Operator's Manual page 59

10. Fine-tune the adjustment nut on the front deck lift
assembly by turning it
To increase the height, turn the adjustment nut
clockwise; to decrease, turn counterclockwise.
2
1
G012430
Figure 94
1. Adjustment nut
2. Jam nut
11. If the front deck links do not have enough adjustment
to achieve accurate cut height , the single point
adjustment can be utilized to gain more adjustment.
12. To adjust the single point system, loosen the two bolts
at the bottom of the height of cut plate. Refer to
95.
(Figure 94).
3 4
2 1
3. Rear deck adjustment
4. Front deck adjustment
1. Bolts at the bottom of the height-of-cut plate
13. If the deck is too low, tighten the single point
adjustment bolt by rotating it clockwise. If the deck is
too high, loosen the single point adjustment bolt by
rotating it counterclockwise
Note: Loosen or tighten the single point adjustment
bolt enough to move the height-of-cut plate mounting
bolts at least 1/3 the length of the available travel
in their slots. This will regain some up and down
adjustment on each of the four deck links.
Figure
1. Single point adjustment bolt
14. Tighten the two bolts at the bottom of the height of cut
plate (Figure
Note: In most conditions, the back blade tip should
be adjusted 6.4 mm (1/4 inch) higher than the front.
15. On both sides of the deck, measure from the level
surface to the back tip of the blade (Postion B). The
59
Figure 95
(Figure 96).
g017036
Figure 96
95). Torque to 37-45 N-m (27-33 ft-lb).