Table of Contents
Advertisement
1.32
Forward Travel Speed Backstop Lever
The backstop lever can be used to limit the
movement of the forward pedal for accurate
forward travel speed, and the clip rate required.
Operate the lever in a forward direction to increase
the travel speed setting and in a rearward direction
to decrease.
Note: This is not a cruise control device. Releasing
the forward travel pedal will allow it to return to
neutral.
Operator Platform Latching Mechanism
WARNING: PREVENT ACCIDENTS -
Never operate the mower without first checking
that the operator platform latching mechanism
is fully engaged and in good working order.
Check behind the seat and ensure that the top
of the platform is flush with the top of the fuel
tank. Also check beneath the tool tray and
ensure that the release lever is padlocked in the
correct position.
IMPORTANT: PREVENT DAMAGE -
Engage the parking brake and lower the
cutterdecks to the ground. Remove ignition key
and close ignition key and close ignition cover
before raising and lowering the platform.
Releasing the platform: Release and remove the
tool tray from the left hand side of the platform.
Release the padlock securing the locking latch
handle with key provided. Move the locking latch
handle towards the front of the mower (position A)
until the latch hooks clear the locking bar and raise
the platform. The gas spring will provide
assistance.
Securing the platform: Lower the platform
carefully. The gas spring will provide assistance.
Move the locking latch handle towards the front
of the mower (position A) as the platform nears
the fully lowered position. This will ensure that the
latch hooks clear the locking bar. Fully lower the
platform and move the locking handle towards the
rear of the mower (position B) until the latch hooks
fully engage the locking bar. Replace the padlock
in order to secure the locking latch handle in place.
OPERATING THE MOWER
2
1. Tool tray
2. Locking latch handle
3. Padlock
B
A
A. Release
B. Lock
3
1.32
1
Advertisement
Table of Contents
