Cutterdecks - Toro 02770 Operator's Manual

1.55

Cutterdecks

Check tyres: Examine all tyres and replace any
that are damaged.
Check safety devices:
WARNING: PREVENT ACCIDENTS - Ensure
that all safety guards, shields and protective de-
vices are securely in place and in good working
order. Check that cutterdeck drive cut outs
operate correctly and that the cutterblades do
not continue to operate when the cutterdecks
are more than 300mm above ground level.
Check fasteners: Check all nuts, bolts, pins and
locking devices. Ensure that they are secured cor-
rectly and replace any that are damaged.
Check underdeck areas:
WARNING: PREVENT ACCIDENTS - Switch
off the engine, apply the parking brake and
remove the ignition key before examining or
working on the underdeck areas.
Gain access to the wing underdeck areas by lifting
the cutterdecks to the transport position. Ensure
that the transport latches and safety locks are se-
cured before working on the cutterdecks.
Gain access to the front underdeck area by using
the following procedure:
1. Fully raise the cutterdeck
2. Switch off the engine, apply the parking brake
and remove the ignition key.
3. Ensure that the transport latch and safety lock
is secured before working on the cutterdeck.
WARNING: PREVENT ACCIDENTS - Seek
assistance when carrying out the following
procedures.
MAINTENANCE 1.55