Leveling The Front, Center Deck; Leveling The Winglet Decks To The Front, Center Deck - Toro 31598 Operator's Manual

8. Install the winglet-deck cover and secure it with the
rubber latch (Figure
Note: Ensure that you slide the cover under the front,
center deck-cover tabs before inserting it onto the
mounting hooks and post.
9. Repeat this procedure on the other winglet.
1. Cover
2. Rubber latch
3
Leveling the Front, Center
Deck
No Parts Required
Procedure
Refer to Adjusting the Height of Cut (page
1. Rotate the blade on each outer spindle until the ends
face forward and backward.
2. Measure from the floor to the front tip of the blade.
3. Adjust the 1/8 inch shims on the front caster fork(s)
to match the desired height of cut.
4. Rotate the blades 180° and measure from the floor to
the rear-facing tip of the blade.
5. Loosen the lower jam nuts on the height-of-cut chain
U-bolt.
6. Adjust the nuts to raise or lower the rear of the mower
deck so that the tips of the front and rear blades have
the same measurement.
7. Tighten the jam nuts.
6).
Figure 6
3. Front, center deck-cover
tabs
4. Mount hooks
26).
4
Leveling the Winglet Decks to
the Front, Center Deck
No Parts Required
Procedure
1. Rotate the blade on each winglet so that it points side
to side.
2. Loosen the bolts and nuts securing the 2 eccentric
spacers to the winglets
1. Winglet
2. Hinge pin
3. Stop bolt
3. Rotate the rear (closest to the traction unit) eccentric
until the outside blade tip is about 3 mm (1/8 inch)
higher than the desired height of cut
Note: There is a notch on the eccentric hex, which is
180° from the lobe on the eccentric cam
Use the notches to reference the location of the lobes
when adjusting the eccentrics.
15
(Figure 7).
Figure 7
4. Eccentric
5. Upper hole
(Figure 7).
(Figure 8).