Specifications; Attachments/Accessories; Before Operation; Before Operation Safety - Toro 31598 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Width of cut
Overall
Front mower deck
Side mower deck
Front and one side mower
deck
Overall width
Mower decks down
Mower decks up (transports)
Overall height
With ROPS
Without ROPS
With cab
Overall length
Minimum ground clearance (at
machine centerline)
Wheel tread (to center of tire)
Front
Rear
Wheel tread (to outside of tire)
Front
Rear
Wheel base
Net Weight (with mower decks)
Without cab
With cab

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro genuine
parts. When it comes to reliability, Toro delivers replacement
parts designed to the exact engineering specification of our
equipment. For peace of mind, insist on Toro genuine parts.
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
488 cm (192 inches)

Before Operation

234 cm (92 inches)
145 cm (57 inches)

Before Operation Safety

361 cm (142 inches)
General Safety
505 cm (199 inches)
•
251 cm (99 inches)
226 cm (89 inches)
•
152 cm (60 inches)
236 cm (93 inches)
445 cm (175 inches)
•
24 cm (9.5 inches)
63 inches (160 cm)
56 inches (142 cm)
•
193 cm (76 inches)
168 cm (66 inches)
193 cm (76 inches)
•
2706 kg (5966 lb)
•
2929 kg (6457 lb)
23
Never allow children or untrained people to operate or
service the machine. Local regulations may restrict the
age of the operator. The owner is responsible for training
all operators and mechanics.
Become familiar with the safe operation of the equipment,
operator controls, and safety signs. Know how to stop
the machine and engine quickly.
Check that all safety devices are attached and
functioning properly. This includes, but is not limited to,
operator-presence controls; safety switches and shields;
the rollover protection system (ROPS); attachments; and
brakes. Do not operate the machine unless all safety
devices are in position and functioning as intended by
the manufacturer.
Always inspect the machine to ensure that the blades,
blade bolts, and cutting assembly are not worn or
damaged. Replace worn or damaged blades and bolts in
sets to preserve balance.
Inspect the area where you will use the machine and
remove all objects that the machine could potentially
throw.
Evaluate the terrain to determine the appropriate
equipment and any attachments or accessories required to
operate the machine properly and safely.