Positioning The Deluxe Seat - Toro 31201 Operator's Manual

Changing the Lumbar Support
The back of the seat can be adjusted to provide a customized
lumbar support for your lower back.
To adjust it, turn the knob, under the left-side armrest, in
either direction to provide the best comfort

Positioning the Deluxe Seat

Figure 19
1. Fore/Aft-adjustment lever
2. Weight-adjustment lever
3. Backrest locking lever
Changing the Weight Adjustment
You can adjust this seat to provide a smooth and comfortable
ride.
Important: To adjust the seat for the drivers weight the
driver must be seated and the ignition key moved to the
On position.
The seat is adjusted for your weight by pulling or pressing the
weight-adjustment lever (Figure
Your weight is adjusted correctly when the arrow is in the
middle, clear area of the viewing window.
Within this viewing area, you can adjust the seat to a minimum
spring movement.
When you have reached the minimum/maximum-weight
adjustment, you can hear it reaching the upper or lower end
stop.
Important: To prevent injury to the operator and/or
damage to the machine, click and adjust the setting for
your weight and the seat before you operate the machine.
Note: To avoid compressor damage during weight
adjustment, do not operate the compressor longer than 1
minute.
(Figure 17).
4. Armrest-adjustment knob
5. Lumbar-support-adjustment
knob
19).
Changing the Seat Position
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
1. To adjust, lift the lever to unlock the seat
2. Slide the seat to the desired position and release lever
to lock in position.
3. Verify that the seat has locked into place by attempting
to move it back and forth.
Note: Do not operate the locking lever while
operating the machine.
Changing the Lumbar Support
The lumbar support increases both the seating comfort and
the performance of the driver.
The back of the seat can be adjusted to provide a customized
lumbar support for your lower back.
By turning the adjustment knob upwards, the curvature in
the upper part of the backrest cushion can be adjusted. By
turning the knob downward, you can adjust the curvature in
the lower part of the backrest cushion
0 = No curvature
1 = Maximum curvature at the top
2 = Maximum curvature at the bottom
Adjusting the Armrests
The armrests can be folded back if required and the height
individually adjusted.
To adjust the armrests for height, separate the round cap
(Figure 19) from the cover, loosen the hexagon nut (13 mm)
behind it and adjust the armrests to the desired position and
tighten the nut. Replace the cap onto the nut.
WARNING
Do not install the armrest in the lowest position as
the seat belt roller might not function properly.
Changing the Armrest Angle
The angle of the armrests can be adjusted for operator
comfort.
To adjust the angle of the armrests, turn the adjustment knob
(Figure 19).
When turning the knob to the outside (+) the front part of
the armrest will be lifted, when turning the knob to inside (-)
it will be lowered.
23
(Figure 19).
(Figure 19).